UTC Fire & Security Americas Corporation Inc 924-2WTTS Manuel D’Utilisation

4.  When the panel displays Enter Code, enter the appropriate 

code and press OK. 

5.  When the panel displays Sensor Test, press OK to start 

the sensor test. 

The panel will prompt you to trip each sensor one at a time. 

6.  To trip the touch screen, 

 XXXXXXXXXXX

.  

You can follow the panel voice prompting to test the sensors 
in any order. 

We recommend that you test the touch screen after all 
programming is completed and whenever a touch screen related 
problem occurs. 

To verify communication between the panel and the touch screen, 
close the panel’s cover to put the panel in run mode and then 
press the System Status icon on the touch screen. The touch 
screen should announce the correct system status. 

If panel sirens do not beep when a touch screen is tripped, use a 
GE RF sniffer (60-401) test tool to verify that the touch screen is 
transmitting. Constant beeps from the RF sniffer indicate a faulty 
touch screen. Two or three beeps from the RF sniffer indicate the 
touch screen is functioning but may have to be relocated.  

1.  Test the touch screen a few inches from the original position. 

2.  Increase the distance from the original position. Retest until 

an acceptable location is found. 

3.  Mount the touch screen in the new location (see Mounting). 

Test a known good touch screen at the same location. 

• 

If transmission beeps remain below the minimum level, avoid 
mounting a touch screen at that location. 

• 

If the replacement touch screen functions, contact GE 
Security for repair or replacement of the faulty touch screen. 

To mount the touch screen: 

1.

 XXXXXXXXXXXXXXXXXXX

 

2. 

XXXXXXXXXXXXXXXXXX 

3. 

XXXXXXXXXXXXXXXXXXX 

Refer to the touch screen Quick Operation Guide for operation 
information. 

When the touch screen batteries are low, the touch screen 
announces Touch Screen Low Battery. The panel announces 
(sensor name) Low Battery. Remove the touch screen from the 
mounting plate and replace all batteries. Avoid touching the touch 
screen face while you are replacing the batteries. After replacing 

the batteries, do a sensor test to realign the touch screen with the 
panel. 

 
Compatibility 

Simon XT (version 1.3 and later)  

Power 

XXXXX 

Battery 
 Type 
 Replace 

with 

 

Voltage, chemistry, form factor 
Manufacturer P/N, Manufacturer P/N, or GE 
approved equivalent 

Dimensions (W × H × D) 

0.0 × 0.0 × 0.0 in. (000 × 000 × 000 mm) 

Operating environment
 Temperature
 Relative 

humidity 

 

00 to 00°F (00 to 00°C) 
0 to 00% noncondensing 

 

 
FCC 

This device complies with part 15 of the FCC rules. 
Operation is subject to the following conditions: 
1. This device may not cause harmful interference. 

2. This device must accept any interference 
received, including interference that may cause 
undesired operation. 
Changes or modifications not expressly approved 
by the party responsible for compliance could void 
the user’s authority to operate the equipment. 

FCC ID: 

XX

 

IC: 

XX 

 

 

For contact information see our Web site: www.gesecurity.com. 

 

2 of 2 

 

P/N 000000 • REV 00.01 • ISS 11DEC09 

Draft