TEKTELIC Communications T0005281 Manuel D’Utilisation
Kona Micro Indoor User Guide
T0005281_UG
Version 0.12
TEKTELIC Communications Inc.
Confidential
Page 11 of 23
Direct DC Power Cable Installation
The Kona Micro Indoor Gateway is powered up with supplied AC-DC power adaptor. The adaptor
provides 12 VDC with positive inner tip as shown below in Figure 5. The connector tip is a
standard DC Barrel connector-straight plug with 2.1 mm (inner), 5.5 mm (outer) diameters.
provides 12 VDC with positive inner tip as shown below in Figure 5. The connector tip is a
standard DC Barrel connector-straight plug with 2.1 mm (inner), 5.5 mm (outer) diameters.
Figure 5: Direct DC Power Connection Polarity
RF Cable Installation
The Kona Micro Indoor Gateway installation requires connection to a LoRa RF antenna. The RF
cable attaches to the reverse SMA connector located side rear of the Gateway. Torque the
connector to 5 in·lbs. The Kona Micro Indoor is not protected from lighting surge as it is intended
for indoor use. Do not connect the unit with external RF antenna.
cable attaches to the reverse SMA connector located side rear of the Gateway. Torque the
connector to 5 in·lbs. The Kona Micro Indoor is not protected from lighting surge as it is intended
for indoor use. Do not connect the unit with external RF antenna.
Note that the 3G/4G modem antenna is internal to the Kona Micro Indoor Gateway.
Copper Ethernet Cable Installation
The Kona Micro Indoor Gateway Ethernet port may be used on a temporary basis for
commissioning and maintenance or may be permanently connected for backhaul.
commissioning and maintenance or may be permanently connected for backhaul.
The Ethernet cable must have minimum 24 AWG conductors and shall be rated for Indoor
application according to local and national electrical codes.
application according to local and national electrical codes.