Robert Bosch Security Solutions Pte Ltd SEC-3402-433 Manuel D’Utilisation
10
en | Installation and Setup
Security Escort Point Tracking Transmitter
2017.11 | SE3v1.0 | DL
Installation Manual
Robert Bosch (SEA) Pte Ltd
3.1.2
Mounting without the mounting plate
1.
If the battery was installed in the point transmitter, remove it at this time.
2.
Using a small screwdriver, gently lift the printed circuit board away from the case
mounting clips. You do not need to remove the cover to remove the board.
mounting clips. You do not need to remove the cover to remove the board.
Figure 3.5: Lift printed circuit board
3.
Rock the board gently to loosen the battery clips from the case and slide the board away
from the mounting clips near the area where the cover connects to the base.
from the mounting clips near the area where the cover connects to the base.
4.
Mount the point transmitter in the desired location, taking note the magnet needs to be
on the same side of the case as the reed switch.
on the same side of the case as the reed switch.
Figure 3.6: Mount point transmitter in desired position
1 Magnet side
2 Mounting holes
3.1.3
Mounting the magnet
Mount the magnet as shown in the following figure. The magnet must mount within 19 mm
(0.75 in.) of the base of the unit.
(0.75 in.) of the base of the unit.