TempSen Electronics Company TEMPOD20B Manuel D’Utilisation
USER MANUAL
UM-PDUB-160217 REV.D
Page 18 / 42
Battery
Tempod data logger uses one user replaceable Panasonic CR2450 lithium battery,
Remaining Battery Indicator
3 bars - Full
2 bars - Good
1 bar – Medium
0 bar – Low, please replace battery NOW
Replace Battery
Please insert a coin in the groove on battery compartment cover to spin it in the direction of OPEN to open battery cover, and take
battery out, then press “View/Mark” or “Start/stop” button several times until LCD changes to blank, otherwise volume of new battery
would probably not be correctly recognized within one hour after battery replacement.
Place a new Panasonic CR2450 battery into battery compartment with positive side upward.
Put cover back to compartment in the position where triangle on cover points to the triangle on logger, then spin cover in the direction of
CLOSE to close battery cover
IATA Compliance
Battery supplied with Tempod passed the Part III, SubSection 38.3 of the UN Manual of Tests and Criteria. Tempod® data logger is also
certified to meet requirements in General Requirements and Section II of Packaging Instruction 970, IATA Dangerous Goods Regulations 58th
Edition. Tempod® complies with RTCA-DO160G Environmental Conditions and Test Procedures for Airborne Equipment, it's allowed to used
in air freight in active status.
WARNING
Please DO NOT try to recharge or heat the battery
Please DO NOT use data logger (excluding external probe) in environment outside of -30.70 to avoid damage to
battery.