GUANGDONG GDA Valve Technology.Co.Ltd GH03-C Manuel D’Utilisation
INTRODUCTION
This remote control system was developed to provide a safe,reliable,and user-friendly remote control system
for gas heating appliances.The system is operated manually from the transmitter.The system operates on radio
frequencies(RF) within a 50-feet range using non-directional signals.The system operates on one of 1,048,576
security codes that are programmed into the transmitter at the factory;the remote receiver’s code must be
matched to that of the transmitter prior to initial use.
for gas heating appliances.The system is operated manually from the transmitter.The system operates on radio
frequencies(RF) within a 50-feet range using non-directional signals.The system operates on one of 1,048,576
security codes that are programmed into the transmitter at the factory;the remote receiver’s code must be
matched to that of the transmitter prior to initial use.
Review COMMUNICATION SAFETY under GENERAL INFORMATION section.This safety feature shuts down
the appliance when a potentially unsafe condition exists.
TRANSMITTER
This remote control SYSTEM offers the user a battery-operated
remote control to power a latching solenoid such as those used with
gas valves used in some heater rated gas logs,gas fireplaces and
other gas heating appliances.
remote control to power a latching solenoid such as those used with
gas valves used in some heater rated gas logs,gas fireplaces and
other gas heating appliances.
The solenoid circuit uses the battery power from the receiver to
operate a solenoid.The circuit has reversing polarity software which
reverses the positive(+)and negative(-)output of the receiver’s battery
power to drive a latching solenoid ON/OFF.The SYSTEM is controlled
by the remote transmitter.
operate a solenoid.The circuit has reversing polarity software which
reverses the positive(+)and negative(-)output of the receiver’s battery
power to drive a latching solenoid ON/OFF.The SYSTEM is controlled
by the remote transmitter.
The transmitter operates on a (2)1.5V AAA batteries.
ALKALINE batteries should always be used for longer battery life and
maximum operational performance.Re-chargeable batteries should
not be used
maximum operational performance.Re-chargeable batteries should
not be used
Before using the transmitter,install the (2)AAA transmitter batteries
into the battery compartment.(Use caution that batteries are installed
in the proper direction)
into the battery compartment.(Use caution that batteries are installed
in the proper direction)
KEY SETTINGS
ON -Operates unit to on position,Manually operated solenoid ON.
OFF -Operates unit to off position,Manually operated solenoid OFF.
MODE -Changes unit from manual mode to thermo mode.
SET -Sets temperature in thermo mode.