ICOM 242700 Manuel D’Utilisation
114
9
SCAN OPERATION
9
qSelect S-2.
wPush [F-3 V/M] to select VFO mode.
eSelect the desired operating mode.
• The operating mode can also be changed while scan-
ning.
rSet [RF/SQL] open or closed.
• See page a left for squelch condition.
• If the
• If the
[RF/SQL] control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
See pgs. 1, 35, 131 for details.
See pgs. 1, 35, 131 for details.
tPush [F-1 SCN] to start the scan.
• Decimal point blinks while scanning.
yWhen the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.
sume setting and the squelch condition.
uTo cancel the scan push [F-1 SCN].
NOTE: If the same frequencies are programmed
into the scan edge memory channels 1A and 1B,
programmed scan does not start.
into the scan edge memory channels 1A and 1B,
programmed scan does not start.
Select
VFO mode
VFO mode
then push [F-1 SCN]
[MENU/GRP] [F-1] [F-3]
[RF/SQL]
■Programmed scan operation
qSelect the desired memory bank, if necessary.
●
● Push [PBT/M-ch/RIT] momentarily to select the
M-ch/RIT function, if the twin PBT is selected.
•
[PBT/M-ch/RIT] indicator (Green) goes out.
●
● Rotate [RIT] (outer) control to select the desired
memory bank.
wSelect S-2.
ePush [F-3 V/M] to select memory mode.
rClose the squelch with [RF/SQL].
tPush [F-1 SCN] to start the scan.
• Decimal point blinks while scanning.
yWhen the scan detects a signal, the scan stops or
pauses depending on the resume setting.
uTo cancel the scan push [F-1 SCN].
NOTE: Two or more memory channels must be
programmed for memory scan to start.
programmed for memory scan to start.
Select
memory mode
memory mode
then push [F-1 SCN]
[MENU/GRP] [F-1] [F-3]
[RF/SQL]
[RIT] (outer) control
■Memory scan operation
Menu group selection
Push
[MENU/GRP] for 1 sec.
Selection from: M, S or G(Graphic)
Menu selection (Example: M)
Push
[MENU/GRP] momentarily.
Selection from: S-1, S-2 or S-3
Either
Y or Z
Either
Y
or
Z