ICOM 242700 Manuale Utente

114

9

SCAN OPERATION

qSelect S-2.

wPush [F-3 V/M] to select VFO mode.

eSelect the desired operating mode.

• The operating mode can also be changed while scan-

ning.

rSet [RF/SQL] open or closed.

• See page a left for squelch condition.
• If the 

[RF/SQL] control function is set as “AUTO,” the

squelch is always open in SSB, CW and RTTY modes.
See pgs. 1, 35, 131 for details.

tPush [F-1 SCN] to start the scan.

• Decimal point blinks while scanning.

yWhen the scan detects a signal, the scan turns

OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.

uTo cancel the scan push [F-1 SCN].

NOTE: If the same frequencies are programmed
into the scan edge memory channels 1A and 1B,
programmed scan does not start.

Select
VFO mode

then push [F-1 SCN]

[MENU/GRP] [F-1] [F-3]

[RF/SQL]

■Programmed scan operation

qSelect the desired memory bank, if necessary.

●

● Push [PBT/M-ch/RIT] momentarily to select the

M-ch/RIT function, if the twin PBT is selected.

•

[PBT/M-ch/RIT] indicator (Green) goes out.

●

● Rotate [RIT] (outer) control to select the desired

memory bank.

wSelect S-2.

ePush [F-3 V/M] to select memory mode.

rClose the squelch with [RF/SQL].

tPush [F-1 SCN] to start the scan.

• Decimal point blinks while scanning.

yWhen the scan detects a signal, the scan stops or

pauses depending on the resume setting.

uTo cancel the scan push [F-1 SCN].

NOTE: Two or more memory channels must be
programmed for memory scan to start.

Select
memory mode

then push [F-1 SCN]

[MENU/GRP] [F-1] [F-3]

[RF/SQL]

[RIT] (outer) control

■Memory scan operation

Push

[MENU/GRP] for 1 sec. 

Selection from: M, S or G(Graphic)

Push

[MENU/GRP] momentarily. 

Selection from: S-1, S-2 or S-3

Either

Y or Z

Either

Y

 or 

Z