TEWS Elektronik GmbH & Co. KG MWT Manuel D’Utilisation
Technical Manual MW-T / Version: 1.6
2013-08-28
7.4. Connecting a LED Signal Tower
The MW-T is equipped with an 8.4“ touch display. By this display the measurement values and
announcements are shown to the operator. The readability of the information on the display is
naturally restricted to relatively small distances. For a signalling over larger distances, a LED signal
tower can be connected to the MW-T through the “DOUT“ connector. If the “DOUT“ connector is
already being used through the connection of an antenna switch, the signal tower can be
connected to the control output of the second switch.
announcements are shown to the operator. The readability of the information on the display is
naturally restricted to relatively small distances. For a signalling over larger distances, a LED signal
tower can be connected to the MW-T through the “DOUT“ connector. If the “DOUT“ connector is
already being used through the connection of an antenna switch, the signal tower can be
connected to the control output of the second switch.
The LED signal tower uses in general the signals “DO1“..“DO3“ of the digital output “DOUT“.
7.5. Connecting a GSM Modem
It is possible to connect a GSM modem to the MW-T through the ‘Ser. Interface’ connector. In order
to do this, the „Ser.Interface“ port of the MW-T must be set to operation type RS232. Operation
type RS232 is the standard setting in distributing the MW-T.
to do this, the „Ser.Interface“ port of the MW-T must be set to operation type RS232. Operation
type RS232 is the standard setting in distributing the MW-T.
TEWS Elektronik GmbH & Co KG, Hamburg
16/24
EIS