Suzhou Bescon Electronics Co. Ltd BRC0550901 Manuel D’Utilisation
User Manual for BRC0550901&RCN1008
The remote control used RF4CE protocol to send RF signals (buttons and rotary wheel) for
device controlling. The remote can be used after pairing with a dedicated device which was
installed with a receiver dongle.
1.product figure (BRC0550901)
device controlling. The remote can be used after pairing with a dedicated device which was
installed with a receiver dongle.
1.product figure (BRC0550901)
2: Pairing operation
Press button “
” and”
”, and hold for 3 seconds; RC will start to send “Pairing
packet” and searching host.
The pairing processed will be auto completely. Below table shows the detail actions in RC:
pressed
press packet send out
holding pressed
repeat packet send out
pressed
(this button should
be pressed within 200ms after the first
button
button
pressed)
release packet send out and then RC start to waiting
for 3 sec
Waiting for 3 sec
If any of two buttons released during this time-window, pairing
operation was cancelled and no RF signal send out
operation was cancelled and no RF signal send out