Dolby Laboratories ACCESSLINK Manuel D’Utilisation
FAL.OM.002372.DRM
Page 38 of 62
Version 1.6
Doremi Labs
5 CaptiView Configuration
The AccessLink device enables customers who do not have a Doremi Digital Cinema
Server to use the CaptiView device using SMPTE ST 430-10 and ST 430-11
protocol from a non-Doremi Digital Cinema server. There are three ways to set up the
AccessLink's CaptiView network: First, the USB method is the primary way to set up the
network of the device; second is the Ethernet Port; and the third method is to use the Serial
Port. Logging in using SSH or serial connection is required to complete the setup of the device.
Server to use the CaptiView device using SMPTE ST 430-10 and ST 430-11
protocol from a non-Doremi Digital Cinema server. There are three ways to set up the
AccessLink's CaptiView network: First, the USB method is the primary way to set up the
network of the device; second is the Ethernet Port; and the third method is to use the Serial
Port. Logging in using SSH or serial connection is required to complete the setup of the device.
5.1 Items to Configure
All the items mentioned below must be configured for a CaptiView to work properly on an
AccessLink (Figure 39, Figure 40, and Figure 41):
AccessLink (Figure 39, Figure 40, and Figure 41):
Network configuration:
◦ IP address
◦ Netmask
◦ Gateway
Auditorium number: Each auditorium in the theater must have its own auditorium number
assigned to the CaptiView Transmitter Dongle.
Server's IP address: The IP address of the server that is going to be used with the
AccessLink must be added to the AccessLink's configuration.
Figure 39: AccessLink
Note: The CaptiView transmitter (if connected to the AccessLink) shall at least be 20cm away
from the AccessLink antenna
from the AccessLink antenna
– usage of a USB extension cable is needed for the CaptiView
transmitter connection.
CaptiView
Transmitter
Port