Fujitsu 600GB 2.5" 10K SAS FTS:ETED6HB-L Manuel D’Utilisation
Codes de produits
FTS:ETED6HB-L
Chapter 1 Components
1.1 Controller Enclosure
1.1 Controller Enclosure
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
15
Copyright 2011 FUJITSU LIMITED
P3AM-5512-02ENZ0
●
Part explanation
•
LEDs
The states of LEDs are listed below.
The states of LEDs are listed below.
Table 1.2
Status and meanings of each LED (2.5" disks)
●
For 3.5" Disks
Figure 1.10 3.5" type disk
shows the slot number of each disk.
Figure 1.11 Disk slot numbers (3.5" type controller enclosure)
WARNING
Do Not
•
System disks are installed in Slot#0 and Slot#1. Never remove
system disks. Doing so will render the ETERNUS DX Disk storage
system unusable.
system disks. Doing so will render the ETERNUS DX Disk storage
system unusable.
LED name
LED status
Disk status
DISK READY
(green)
The disk is operating normally.
(blinks green)
DISK FAULT
(orange)
The disk is in error status.
(blinks orange)
In response to commands from Microsoft Virtual Disk
Service (VDS), the location of the disk is identified.
Service (VDS), the location of the disk is identified.
WARNING
Do Not
•
System disks are installed in Slot#0 and Slot#1. Never remove
system disks. Doing so will render the ETERNUS DX Disk storage
system unusable.
system disks. Doing so will render the ETERNUS DX Disk storage
system unusable.
DISK READY/FAULT LED
Slot#0
Slot#4
Slot#8
Slot#1
Slot#5
Slot#9
Slot#2
Slot#6
Slot#10
Slot#3
Slot#7
Slot#11