Fujitsu 600GB 2.5" 10K SAS FTS:ETED6HB-L Manuel D’Utilisation
Codes de produits
FTS:ETED6HB-L
Chapter 1 Components
1.1 Controller Enclosure
1.1 Controller Enclosure
ETERNUS DX60 S2 Disk storage system User’s Guide -Operation-
16
Copyright 2011 FUJITSU LIMITED
P3AM-5512-02ENZ0
●
Part explanation
•
LEDs
The states of LEDs are listed below.
The states of LEDs are listed below.
Table 1.3
Status and meanings of each LED (3.5" disks)
1.1.4
Components (Rear)
This section describes the controllers and the power supply units in the rear of the controller
enclosure.
enclosure.
1.1.4.1
Controllers
The controller contains a CPU, cache memory, System Capacitor Unit (SCU), non-volatile mem-
ory, host interface adapters, drive interface (DI) ports, and LAN ports.
The controller controls all operations in the ETERNUS DX Disk storage system.
ory, host interface adapters, drive interface (DI) ports, and LAN ports.
The controller controls all operations in the ETERNUS DX Disk storage system.
■
FC model
Figure 1.12 Controller (FC model)
LED name
LED status
Disk status
DISK READY/
FAULT
FAULT
(green)
The disk is operating normally.
(blinks green)
(orange)
The disk is in error status.
(blinks orange)
In response to commands from Microsoft Virtual Disk
Service (VDS), the location of the disk is identified.
Service (VDS), the location of the disk is identified.
FC LINKUP/FAULT LED
FC port (0 (Left), 1 (Right))
FC port (0 (Left), 1 (Right))
DI (OUT) port
LAN (RMT) port
PWC port
DI (OUT) LINKUP LED
MASTER LED
ACT LED
LINK LED
LINK LED
SCU STATUS LED
UNIT READY/FAULT LED
IDENTIFY LED
LAN (MNT) port