Grid Connect Inc. ESP32P001 Manuel D’Utilisation
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
Déclarationd'exposition aux radiations:
Cetéquipementestconforme aux limitesd'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cetéquipementdoitêtreinstallé et utilisé avec un minimum de
20cm de distance entre la source de rayonnement et votre corps
Cetéquipementestconforme aux limitesd'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cetéquipementdoitêtreinstallé et utilisé avec un minimum de
20cm de distance entre la source de rayonnement et votre corps
OEM Integration Instructions
：
This device is intended only for OEM integrator under the following conditions. The module
can be used as certified in a host product if:
can be used as certified in a host product if:
1. The antenna is installed such that 20 cm is maintained between the antenna and any end
user.
user.
2. The transmitter module and antenna are not co-located with any other transmit or antenna.
3. The module is only used with the antenna(s) originally tested and certified with this module.
As long as 3 conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirement with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirement with this module installed (for example, digital device emissions, PC
peripheral requirements, etc.).
The final end product must be labeled in a visible area with the following:
Contains FCC ID: 2AFC3ESP32P001, IC: 22503-ESP32P001
The GC-ESP32-PORT-N may only be used with the following antennas:
Antenna Type
Manufacturer
Frequency Range
(MHz)
Maximum Peak
Antenna Gain (dBi)
Whip
V.TORCH VTWFA-3
2400-2480
3dBi
Trace
Airgain N2420
2400-2480
3.8dBi
any 50 Ohm antenna of the same type and frequency range, with equal or lesser gain.
IMPORTANT NOTE
：
In the event that the above conditions cannot be met (for example certain device configuration
or co-location with another transmitter), then the FCC / ISED authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID / IC
number of the module cannot be used on the final product. In these and circumstance, the
OEM integrator will be responsible for re-evaluating. The end product (including the
transmitter) and obtaining a separate FCC authorization.
or co-location with another transmitter), then the FCC / ISED authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID / IC
number of the module cannot be used on the final product. In these and circumstance, the
OEM integrator will be responsible for re-evaluating. The end product (including the
transmitter) and obtaining a separate FCC authorization.