Develco Products MOSZB140 Test Setup Photos

 

a.

b.

c.

d.

e.

f.

g.

h.

i.

1.  When batteries are inserted, the Motion 

Sensor Mini will automatically start 
searching (up to 15 minutes) for a Zigbee 
network to join. 

2.  Make sure that the Zigbee network is open 

for joining devices and will accept the 
Motion Sensor Mini.

3.  While the sensor is searching for a Zigbee 

network to join, the LED flashes red.

4.  When the sensor is connected to a network, 

it wil stop flashing.

1.  If you have a sensor with 

a plastic stand included, 
you can insert the stand 
in the opening on the 
back of the sensor as 
shown on the drawing.

2. Place the standing sensor 

on the shelf or on a desk.

1.  Open the casing, and use the sensor part 

with oval holes to mark the screw holes on 
a ceiling or a wall.

•  Place the sensor free of curtains and other 

obstacles.

•  Avoid placing the Motion Sensor Mini close 

to a heating/cooling source.

•  Avoid placing the Motion Sensor Mini in 

direct sunlight or bright light.

•  Place the sensor indoors at a temperature 

between 0-50°C. 

•  Its angle of detection from above, the sides, 

and below must be 45°. 

•  Place the Motion Sensor Mini in a location 

with a clear view of the monitored area and 
the windows. 

•  The distance from the sensor to a fireplace 

or a stove must be at least four meters. 

•  The Motion Sensor Mini must be reachable 

for battery testing and maintenance.

The compact Motion Sensor Mini allows the 
user to detect occupancy. With the Motion 
Sensor Mini, the user can set the light to 
turn on and off as people come and go. The 
motion sensor is PIR based and is able to 
sense movement up to 9 meters from the 
sensor. 

Motion Sensor Mini includes two logical 
outputs – one with high sensitivity for 
occupancy and one with a lower sensitivity 
for alarm.

Version 1.1

1.  If you have a sensor with a bracket included, 

you can mount the sensor with this bracket 
in a corner or on the ceiling. 

2.  Use the bracket to mark the screw holes on 

the two walls in the corner of the room or 
on the ceiling.

3.  Use the two screws in the bag marked “A” 

to install the bracket in the marked place.

3.  Alternatively, you can use the adhesive 

tape from bag “A” to mount the sensor.

4.  Insert batteries and make sure that the 

battery polarity is correct (+/-).

5.  Close the casing of the sensor. 

4.  Alternatively, you can use the adhesive 

tape from bag “A” to mount the bracket.

5.  Open the casing of the sensor. 

6.  Place the part with oval holes against the 

already mounted bracket.

7.  Take two screws from the bag marked “B”. 

Mount one screw through each oval hole 
and into two holes on the bracket.  

8.  Insert batteries and make sure that the 

battery polarity is correct (+/-).

9.  Close the casing of the sensor. 

2.  Mount the sensor on the wall or the ceiling 

by installing one screw from the bag 
marked “A” through each oval hole.

Red LED light is flashing every second (up to 
15 minutes).

The  motion  sensor  will  automatically  flash 
green every time movement is detected by 
the Intruder Alarm System (IAS), no matter if 
the alarm system is activated or deactivated. 
The  green  flashes  can  help  you  determine 
if the placement of the sensor is suitable for 
alarm purposes.         

The  device  will  flash  red  twice  every  minut 
when the battery is low.