QSR Automations Inc. KP9000 Manuel D’Utilisation
KP-9000 Wireless Keypad: User’s Guide
4
Out of the Box
The KP-9000 Wireless Keypad arrives with dongle stored inside.
1. Unscrew the back of the keypad and remove the dongle.
2. Install six AAA batteries. (The keypad only requires two AAA batteries to
2. Install six AAA batteries. (The keypad only requires two AAA batteries to
function, but up to six batteries may be installed at once to increase the
keypad’s battery life.)
3. Plug the dongle into the Kitchen controller.
4. The keypad and dongle have been pre-paired, and will pair automatically.
4. The keypad and dongle have been pre-paired, and will pair automatically.
Note: It is recommended that you label the keypad and its corresponding dongle upon
unpacking to avoid confusion should they ever become separated.
LED Indicators
Keypad LED
There is one LED visible in the upper left portion of the keypad. The following table
describes what the different LED messages are conveying.
Mode
LED
Description
Unpaired
No LED
The default when not paired with a
dongle. Special keypress (upper left and
bottom right keys for 3s) required to
enter pairing mode. Unpaired is the
mode for factory storage and shipping.
Keypad will shut ‘off’ in this state, using
the lowest power consumption possible
with batteries installed.
Searching Blinking low-duty Amber
(Amber also on very low-
duty cycle for low battery)
Dongle has been previously paired but is
not currently found. The keypad will
search indefinitely in an attempt to
reconnect. However, it will only search 1
minute at high speed (10Hz) before
dropping back to power savings (1Hz).