Panasonic CU-2E15GBE Manuel D’Utilisation

 

56 

1.  Turn power on. 
2.  Press the CHECK button on the remote controller continuously for 5 seconds. 
3.  “- -” will be displayed on the remote controller display. Note: Display only for “- -”. (No transmitting signal, no 

receiving sound and no Power LED blinking.) 

4.  Press the “TIMER” ▲ or ▼ button on the remote controller. The code “H00” (no abnormality) will be 

displayed and signal will be transmitted to the main unit. The power LED lights up. If no abnormality is stored 
in the memory, three beeps sound will be heard. 

5.  Every press of the button (up or down) will increase abnormality numbers and transmit abnormality code 

signal to the main unit. 

6.  When the latest abnormality code on the main unit and code transmitted from the remote controller are 

matched, power LED will light up for 30 seconds and a beep sound (continuously for 4 seconds) will be 
heard. If no codes are matched, power LED will light up for 0.5 seconds and no sound will be heard. 

7.  The breakdown diagnosis mode will be canceled unless pressing the CHECK button continuously for 5 

seconds or operating the unit for 30 seconds. 

8.  The same diagnosis can be repeated by turning power on again. 

 

1.  Turn power on. 
2.  Press the AUTO button for 5 seconds (A beep receiving sound) on the main unit to operate the unit at 

Forced Cooling Operation modes. 

3.  Press the CHECK button on the remote controller for about 1 second with a pointed object to transmit signal 

to main unit. A beep sound is heard from main unit and the data is cleared. 

1.  Press the AUTO button (A beep receiving sound) on the main unit to operate the unit. (Remote control will 

become possible.) 

2.  The unit can temporarily be used until repaired. 

 

Error Code 

Operation 

Temporary items 

H27, H28 

Cooling, Heating 

Emergency operation with limited power