Wilson Electronics 311103 Manuel D’Utilisation

ENGLISH

2.   Run the Outside Antenna cable into 

the car. The cable is strong enough 

that it may be shut in most vehicle 

doors without damaging the cable. 

For a cleaner look, carefully pull down 

the door seal, run the cable under 

the seal, and push the seal back into 

place. This method reduces wear 

on the cable as the door opens and 

closes.

3.  Install the Low-Profile Inside Antenna.
 

•  Identify a place on the right side of 

the driver’s seat to mount the Inside 

Antenna. The location should be at 

least 18 inches but no more than 

36 inches from where the cellular 

device will be used.

 

 •  Install the Inside Antenna at the 

same angle as the cell phone when 

held in use or near the laptop’s 

cellular data card to maximize signal 

strength.

 

  For a more professional look, you 

can install the Inside Antenna 

underneath a car seat cover or 

upholstery.

 

•  When you have tested the 

functionality of your Signal Booster, 

mount the Inside Antenna by peeling 

off the backing of the Velcro

®

 and 

attach it to your selected location 

on the seat and secure the Inside 

Antenna.

4.   Place and connect the Drive 3G-X 

Signal Booster.

 

•  Select a location for the Signal 

Booster that is free from excessive 

heat, direct sunlight and moisture 

and that has proper ventilation. 

Good locations include underneath 

a seat or under the dashboard.

 

•  Connect the wire from the Outside 

Antenna to the port labeled “Outside 

Antenna” on the Signal Booster.

 

•  Connect the wire from the Inside 

Antenna to the port labeled “Inside 

Antenna” on the Signal Booster.

 

•  Plug the power adapter into 

vehicle’s 12V DC power supply 

and attach the cord to the side of 

Power Booster labeled “Power.” 

NOTE: Do NOT connect the power 

to the Signal Booster until you have 

connected both the Inside and 

Outside Antennas.

 

•  Power up your Signal Booster by 

flipping the switch on the back of 

the DC power adapter on. A red 

light should appear on the power 

adapter.

Note: The Drive 3G-X Signal Booster 

may remain on, in vehicles whose 12V 

DC power sources do not automatically 

shutdown when the vehicle is turned 

off. This could result in discharging the 

vehicles battery in one to two days. 
Note: Some 12V DC power sources are 

shut down when the vehicle ignition is 

turned to off. Refer to your vehicle owners 

manual for specifics related to your 

vehicle. 
Note: The aluminum casing of your Signal 

Booster will adjust to the temperature of its 

environment, but is designed to protect the 

Signal Booster technology. For example, 

in the summer, the Signal Booster case 

may be as hot as 150 degrees inside your 

vehicle. These high temperatures will 

NOT damage the Signal Booster, nor do 

they pose a fire risk to the vehicle. Again, 

be sure to place your Signal Booster in a 

location with adequate ventilation and away 

from direct sunlight or moisture.