Wilson Electronics 311103 Manuel D’Utilisation

ENGLISH

Lights Off 
1.   Check connections on the power 

supply to see that it is firmly plugged 

into both the Drive 3G-X and the 

power source.

2.   If using a DC power supply in your 

vehicle, ensure the power supply is 

properly inserted. Then check the 

12 volt power from the car socket 

and the fuse. Replace the fuse if 

necessary. 

3.   If using a power strip in a building, 

ensure the power strip is plugged 

in and turned on and that power is 

coming from the outlet.

NOTE: The Signal Booster can be reset by 

disconnecting and reconnecting the power 

supply. 
For additional descriptions on 

troubleshooting, see the install video at 

weboost.com/us/drive3G-Xvideo .

Select a location for mounting the antenna.  

The best location would be centered on the 

vehicle roof, although other locations are 

acceptable. 
Roof mount only:  For mounting the 

antenna to the roof of your vehicle, use 

weBoost #905814 (3/8 in. w/RG58 cable) 

or #907414 (3/8 in. w/RG174 cable), which 

must be purchased separately 

(A).  Drill a 

hole in the desired location for mounting.  

The size of the hole should be 3/8 in. 
The plastic washer 

(B) should be placed 

over the threads of the NMO mount 

(A).  

From the inside of the vehicle, insert the 

threaded portion of the mount up through 

the hole in the vehicle.   
From the top of the vehicle, screw the 

threaded nut 

(D) onto the mount threads 

coming up through the roof and tighten 

until secure. 
The black rubber washer 

(C) should now 

be positioned around the threaded nut.  
Working from the inside of the vehicle, 

securely route and position the cable 

provided. 

The Signal Boost includes two indicator 

lights on the front of the Drive 3G-X. The 

indicator lights will either be green or red.

 Green indicates that the booster is 

powered and operating at maximum 

gain. 

 Solid  Red indicates that the booster 

has shut off on the associated 

frequencies to prevent oscillation 

(feedback). 

 Green/red  Blinking indicates that the 

booster is operating at a reduced gain 

to prevent oscillation (feedback).

Fixing Red Light Issues 
If one or more lights on the Signal Boost 

are red: 
1.  Make sure all connections are tight. 
2.   Increase the distance between the 

outside antenna and the Drive 3G-X, 

by moving them horizontally and/or 

vertically farther apart until the light(s) 

change to green. Remember to keep 

the antenna at least 6 inches from 

any window or sunroof.

3.   Follow the same steps for a green/red 

blinking light until the light goes solid 

green.

4.   If more separation is not possible and 

the coverage of the booster is too 

small with a green/red blinking light 

indicating reduced gain, contact the 

weBoost Customer Support Team for 

assistance: 866-294-1660.