Enda EI7412-SM-AS12 SW Universal LED-display EI7412 0 - 20 mA/4 - 20 mA/0 - 1 V/0 - 10 V Assembly dimensions 68 x 68 mm EI7412-SM-AS12 SW Fiche De Données

ENDA EI7412 is intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding must be 
grounded on the instrument side. During an installation, all of the cables that are connected to the device must be free of energy. The device 
must be protected against inadmissible humidity, vibrations, severe soiling and make sure that the operation temperature is not exceeded. All 
input and output lines that are not connected to the supply network must be laid out as shielded and twisted cables. These cables should not be 
close to the power cables or components. The installation and electrical connections must be carried on by a qualified staff and must be 
according to the relevant locally applicable regulations.  

1) Mains supply cords shall meet the requirements of  IEC 60227 or IEC 60245. 
2) In accordance with the safety regulations, the power supply switch shall bring the identification of the relevant instrument and it
   should  be easily accessible by the operator.

Note :

Neutral

Line

Holding screw
0.4-0.5Nm 

Equipment is protected throughout
by DOUBLE INSULATION.

ENDA

75mm

8

4

m

m

 68     mm

+0.7

 6

8

  

  

 m

m

+

0

.7

97mm

Note  1) While panel mounting, additional distance required 
              for connection cables should be considered.
          2) Panel thickness should be maximum 10mm.
          3) If there is no 90mm free space at back side of the device,
              it would be difficult to remove it from the panel.

  -  Push the flush-mounting 
     clamp in direction 1 as    
     shown in the figure left.
  -  Then, pull out the clamp in  
     direction 2. 

For removing mounting clamps:

7

2

m

m

7

8

m

m

ENDA

ENDA

ENDA

ENDA

ENDA

ENDA

ENDA

4./4     EI7412-E