Insys ISDN Terminal Adapter 4.0 11-02-01-02-00.015 Manuel D’Utilisation
Codes de produits
11-02-01-02-00.015
Configuration
15
Version 2.02 – 01.04
5.1.3 Configuration With X3.PAD
To execute a TA+ configuration command out of the X.3 - PAD command mode you have
to enter the command exec cmd.
to enter the command exec cmd.
Use the command conf to start the TA+ configurator.
You can leave the TA+ configuration program with the command quit.
Note:
After changing a value marked with (#1), you have to enter the commands
save
save
and go additionally. This is necessary to save and activate the new pa-
rameter.
5.1.3.1 X.3 Command Set
If you connect a serial interface to the X.31 service, you can use the integrated PAD of the
INSYS ISDN TA. You can use for example the command stat to display the status of the
connection.
Use the configuration command cmds = 1 to set the PAD mode.
INSYS ISDN TA. You can use for example the command stat to display the status of the
connection.
Use the configuration command cmds = 1 to set the PAD mode.
The following PAD-Commands according to X.28/X.29 are supported:
• (dot)
• (dot)
Displays PAD identification
[Pxxx-][R ][N<nuipwd> ][G<cug> ]X25number[I<ISDNnumber>][D<userdata>]
Establishes an X.25 connection
P use
P use
packet
size
xxx
for X.25 connection
R
request the facility reverse charging (only for X.25)
G
access to a closed X.25 user group
O
outgoing call from a closed X.25 user group
N
use NUI and password in call packet, allowed characters:
a-z, A-Z, 0-9. (overrides setting of nui configuration com-
mand)
a-z, A-Z, 0-9. (overrides setting of nui configuration com-
mand)
X25number dialed X.25 call number
ISDNnumber ISDN call number for a dialed B channel connection
D
ISDNnumber ISDN call number for a dialed B channel connection
D
separator for user data: D, P or ,
clr
terminate an X.25 connection
stat
displays the PAD connection status
set
sets the PAD profile to profile 0
set x:n
sets the PAD profile parameter x to value n
prof x
configures to the PAD profile x, x = 0..7, 90, 91
prof?
displays the configured PAD profile parameters
par [x][,x] displays all configured PAD profile parameters or the PAD parameter x par
without parameter displays all settings