Insys ISDN Terminal Adapter 4.0 11-02-01-02-00.015 Manuale Utente

Configuration 

15 

Version 2.02 – 01.04 

 

 

To execute a TA+ configuration command out of the X.3 - PAD command mode you have 
to enter the command exec cmd. 

Use the command conf to start the TA+ configurator. 

You can leave the TA+ configuration program with the command quit. 

Note: 

After changing a value marked with (#1), you have to enter the commands  
save

  and  go  additionally. This is necessary to save and activate the new pa-

rameter. 

If you connect a serial interface to the X.31 service, you can use the integrated PAD of the 
INSYS ISDN TA. You can use for example the command stat to display the status of the 
connection. 
Use the configuration command cmds = 1 to set the PAD mode. 

The following PAD-Commands according to X.28/X.29 are supported: 
•    (dot) 

Displays PAD identification 

 
[Pxxx-][R ][N<nuipwd> ][G<cug> ]X25number[I<ISDNnumber>][D<userdata>] 

Establishes an X.25 connection 
P  use 

packet 

size 

 for X.25 connection 

R  

request the facility reverse charging (only for X.25) 

G  

access to a closed X.25 user group   

O  

outgoing call from a closed X.25 user group 

use NUI and password in call packet, allowed characters:
  a-z, A-Z, 0-9. (overrides setting of nui configuration com-
mand) 

X25number   dialed X.25 call number 
ISDNnumber   ISDN call number for a dialed B channel connection 
D  

separator for user data: D, P or , 

clr 

terminate an X.25 connection 

stat 

displays the PAD connection status 

set 

sets the PAD profile to profile 0 

set x:n 

sets the PAD profile parameter x to value n 

prof x 

configures to the PAD profile x, x = 0..7, 90, 91 

prof? 

displays the configured PAD profile parameters 

par [x][,x]  displays all configured PAD profile parameters or the PAD parameter x par 

without parameter displays all settings