Insys Modem 56k 4.1 m/UL 11-02-01-01-40.022 Manuel D’Utilisation
Codes de produits
11-02-01-01-40.022
Initial Operation
INSYS Modem 56k UL
6 Juni
05
3.3 Installation Steps
1.
Mounting on DIN rail:
simply clip on
2.
Power supply:
a) Connect earth cable to GND
b) Connect power supply cable to 10..60 VDC
Note: Maximum ratings at pins 2 and 3 must not be exceeded!
c) Connect to power supply
The power LED lights up on successful installation.
a) Connect earth cable to GND
b) Connect power supply cable to 10..60 VDC
Note: Maximum ratings at pins 2 and 3 must not be exceeded!
c) Connect to power supply
The power LED lights up on successful installation.
3.
Telephone network:
a) Plug the TAE cable into the middle of the RJ-45 socket on the front of the hous-
a) Plug the TAE cable into the middle of the RJ-45 socket on the front of the hous-
ing
or alternatively
install via screw terminal on the bottom according to description (b2, b1, a1, a2,
NC).
NC).
c) connect cable to the TAE plug
Disconnect the INSYS Modem 144/336/56K from the phone line immediately in case of
any fault or functional irregularities – e.g. when the OFF-Hook-LED switches on immedi-
ately - and contact your service partner. In order to preserve your guarantee please do
not open or interfere with the modem.
any fault or functional irregularities – e.g. when the OFF-Hook-LED switches on immedi-
ately - and contact your service partner. In order to preserve your guarantee please do
not open or interfere with the modem.
4.
Connecting PC/terminal:
Plug the enclosed RS 232 interface cable into housing front and connect with
PC/terminal.
Plug the enclosed RS 232 interface cable into housing front and connect with
PC/terminal.
5.
Checking successful installation:
Execute a short test from your terminal program (e.g. HSComm terminal window,
HyperTerminal, TeraTermPro, ProcommPlus). Enter the command “AT” and press
the “ENTER” button. If “OK” appears on your screen the INSYS Modem
144/336/56K has been successfully installed.
Execute a short test from your terminal program (e.g. HSComm terminal window,
HyperTerminal, TeraTermPro, ProcommPlus). Enter the command “AT” and press
the “ENTER” button. If “OK” appears on your screen the INSYS Modem
144/336/56K has been successfully installed.
6.
Connection test:
Start a connection from your terminal program:
• Dial the following number 0101901929 (ATDT0101901929)
Start a connection from your terminal program:
• Dial the following number 0101901929 (ATDT0101901929)
Attention:
For PABXs which require a „0“ for connection set-up, please enter
the following ATX3DT0,0101901929
the following ATX3DT0,0101901929
• OFF-Hook-LED lights up
• Modem dials
• After some time (not more than 1 minute) the CONNECT message appears and
• Modem dials
• After some time (not more than 1 minute) the CONNECT message appears and
the DCD LED switches on
10
9
8
7
3
2
6
1
4
5
1
2
3
4
5
6
7
8
9
10
GND
X1
10...60 VDC
GND
GND
RESET
GND
INPUT 1
INPUT 2
GND