Gigaset E36 HANDGIGAE36 Manuel D’Utilisation
Codes de produits
HANDGIGAE36
6
First steps
Gigaset E36 / IM1_en / A31008-M1853-R101-2-6Z19 / starting.fm / 21.05.2007
Ver
si
on 4, 16.
09.20
05
On the handset
Menu§
¢
Settings
¢
§OK§
¢
Handset
¢
§OK§
¢
Register Handset
¢
§OK§
¢
Enter
system PIN of base station
(default status: 0000)
¢
§OK§
On the base station
Press and hold the registra-
tion/paging key on the base
station (min. 1 sec.).
Registering the Gigaset E36 on other
GAP-enabled base stations
On the handset:
§Menu§
¢
Settings
¢
§OK§
¢
Handset
¢
§OK§
¢
Register Handset
¢
§OK§
¢
Enter system PIN of base
station (default status: 0000)
¢
§OK§
.
On the base station: Start to register the
handset on the base station as described
in its user guide.
Charging the batteries
¤
Plug the mains adapter of the charging
cradle into the power socket.
¤
Place the handset in the charging cra-
dle with its display facing forward.
To charge the batteries, leave the handset
in the charging cradle. Battery charging is
indicated in the top right of the display by
a flashing battery icon
e if the handset
is switched on. During handset operation,
the battery icon indicates the charge sta-
tus of the batteries (page 1).
Initial charging and discharging of
batteries
The correct charge status can only be dis-
played when the batteries are first fully
charged and discharged through use.
¤
To do this, leave the handset in the
charging cradle without interruption
until the battery icon stops flashing in
the display (approx. 6 hours).
¤
Once the batteries are fully charged,
remove the handset from the charging
cradle and do not put it back again until
the batteries are fully discharged.
Please ensure the following:
u Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and re-
insert them.
u The batteries may warm up as they are
charging. This is not dangerous.
u After a time the charge capacity of the
batteries will decrease for technical rea-
sons.
Setting the date and time
§Menu§
¢
Settings
¢
§OK§
¢
Date/Time
¢
§OK§
~
Enter the day, month and year
with 6 digits and press
§OK§
.
Use
q to move between the
fields.
~
Enter hours and minutes with
4 digits (e.g. 0 7 1 5 for
07.15 hrs) and press
§OK§
. Use
q to move between the
fields.
Once the phone is registered and the
time set, the idle display looks as shown
on page 1.
Your phone is now ready for use.
Note:
After the first battery charge and discharge
you may replace your handset in the charging
cradle after every call.
Note:
You will find explanations for the symbols and
typographical conventions used in this user
guide in the appendix, page 14.