Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Fiche De Données

SAM4E [DATASHEET]

Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14

390



0 (HIGH): The supply monitor detected VDDIO higher than its threshold at its last measurement.

1 (LOW): The supply monitor detected VDDIO lower than its threshold at its last measurement.



0 (RC): The slow clock, SLCK is generated by the embedded 32 kHz RC oscillator.

1 (CRYST): The slow clock, SLCK is generated by the 32 kHz crystal oscillator.



0 (LOW): FWUP input is tied low.

1 (HIGH): FWUP input is tied high.



0 (NO): No wake-up due to the assertion of the WKUP0 pin has occurred since the last read of SUPC_SR.

1 (PRESENT): At least one wake-up due to the assertion of the WKUP0 pin has occurred since the last read of SUPC_SR. 



0 (NO): No wake-up due to the assertion of the WKUP1 pin has occurred since the last read of SUPC_SR.

1 (PRESENT): At least one wake-up due to the assertion of the WKUP1 pin has occurred since the last read of SUPC_SR.



0 (DIS): The corresponding wake-up input is disabled, or was inactive at the time the debouncer triggered a wake-up 
event.

1 (EN): The corresponding wake-up input was active at the time the debouncer triggered a wake-up event.