STMicroelectronics STEVAL-TLL009V1 Camera flash based on the STCF07 STEVAL-TLL009V1 STEVAL-TLL009V1 Fiche De Données
Codes de produits
STEVAL-TLL009V1
STCF07
Detailed description
Doc ID 16757 Rev 3
13/26
8.6 STCF07
protection
features
8.6.1
Peak current and short-circuit protection
When the peak inductor current exceeds the maximum switch peak current limit of 2.3 A, the
PWM controller turns off and is enabled at the next oscillation period.
PWM controller turns off and is enabled at the next oscillation period.
8.6.2 Overvoltage
protection
The device includes power failure protection, which stops the operation of the PWM
controller when the voltage at the pin V
controller when the voltage at the pin V
OUT
exceeds the OVP threshold. When the voltage
on pin V
OUT
is reduced by OV
HYST
, the operation of the controller recovers automatically.
8.6.3
Thermal shutdown protection
Internal thermal shutdown protection switches off the device when the junction temperature
exceeds 140 °C (typ). The hysteresis comparator allows the PWM controller to restart
automatically when the temperature is reduced to 120 °C.
exceeds 140 °C (typ). The hysteresis comparator allows the PWM controller to restart
automatically when the temperature is reduced to 120 °C.
8.6.4
Sensing of LED temperature with the NTC resistor
The device is capable of switching off the power circuit when a high temperature on the LED
is detected. (see
is detected. (see
If the sensing LED temperature feature is not used, NTC pin must be left floating and RX pin
must be grounded.
must be grounded.
Figure 4.
Startup: LED current rise time
T
ON
< 2 ms
ENABLE
I
OUT
I
LED
T
ON
< 2 ms
ENABLE
I
OUT
I
LED