Manuels d'utilisation pour STMicroelectronics STEVAL-TLL009V1 Camera flash based on the STCF07 STEVAL-TLL009V1

Table des matières

• Table 1. Device summary

  1
• 1 Block diagram

  4
  • Figure 1. STCF07 block diagram

    4
• 2 Pin configuration

  5
  • Figure 2. STCF07 pin connections (top view)

    5
  • Table 2. STCF07 pin description

    5
• 3 Maximum ratings

  6
  • Table 3. Absolute maximum ratings

    6
  • Table 4. Thermal data

    6
• 4 Application information

  7
  • Figure 3. Application schematic diagram

    7
  • Table 5. List of external components

    7
• 5 Electrical characteristics

  8
  • Table 6. Electrical characteristics

    8
• 6 Introduction

  10
• 7 Logic pin description

  11
  • 7.1 CSEL pin

    11
  • 7.2 FAULT pin

    11
  • 7.3 ENABLE pin

    11
• 8 Detailed description

  12
  • 8.1 Buck-boost converter

    12
  • 8.2 High current mode

    12
  • 8.3 Low current mode

    12
  • 8.4 Shutdown mode

    12
  • 8.5 Soft-start

    12
    • Figure 4. Startup: LED current rise time

      13
  • 8.6 STCF07 protection features

    13
    • 8.6.1 Peak current and short-circuit protection

      13
    • 8.6.2 Overvoltage protection

      13
    • 8.6.3 Thermal shutdown protection

      13
    • 8.6.4 Sensing of LED temperature with the NTC resistor

      13
      • Figure 5. Typical LED temperature sensing application with the NTC resistor

        14
    • 8.6.5 Undervoltage lockout function

      14
• 9 PCB design

  15
  • 9.1 PCB design rules

    15
  • 9.2 PCB design of the demonstration board

    16
    • Figure 6. Top layer

      16
    • Figure 7. Bottom layer

      16
    • Figure 8. Top overlay

      17
  • 9.3 Schematic of the demonstration board

    18
    • Figure 9. Schematic diagram of the STCF07 demonstration board

      18
• 10 Typical performance characteristics

  19
  • Figure 10. IOUT 80 mA vs. VIN

    19
  • Figure 11. IOUT 800 mA vs. VIN

    19
  • Figure 12. Efficiency vs. VIN

    19
  • Figure 13. Efficiency vs. VIN, IO = 400 mA

    19
  • Figure 14. Line transient

    19
• 11 External component selection

  20
  • 11.1 Input and output capacitor selection

    20
  • 11.2 Inductor selection

    20
  • 11.3 LED selection

    20
  • 11.4 RHC selection

    20
  • 11.5 RLC selection

    21
  • 11.6 NTC and RX resistor selection

    21
• 12 Package mechanical data

  22
• 13 Revision history

  25
  • Table 7. Document revision history

    25