Reflecta Super 8 Scanner 66020 Fiche De Données
Codes de produits
66020
8
Installing Hardware
Connect the Super 8 Pro Scanner to a power source.
1. Locate the power switch on the lower left side of the scanner.
2. Plug the AC adapter into an AC power source FIRST before plugging it into
the scanner.
3. Attach the USB cable to the computer using the standard USB adapter end.
Attach the USB adapter end of the cable to back panel of the scanner.
4. Open the reel arm.
Ensure the scanner does NOT have a film reel loaded, turn the scanner ON.
MAKE SURE THERE IS ENOUGH ROOM IN FRONT OF THE SCANNER FOR THE
REEL ARM TO EXTEND FULLY.
Calibration Light Source (First time use)
1. Open the Case
2. Turn on Power
3. Connect to USB to PC
3. Connect to USB to PC
4. Wait for LED light to turn “Orange”
5. Activate the CyberView S8 Software
5. Activate the CyberView S8 Software
6. Create a New Movie Plan and click “Next” button
7. click “Calibration” button
7. click “Calibration” button
8. After Finish Calibration click “OK” button to finish the calibration
Note: Please make sure the film is not install to Super 8 Scanner when you do
calibration function
Install Super 8 Scanner
1. Open the Case
2. Open the Reel Arm
2. Open the Reel Arm
3. Install movie film reel to Supply Reel Arm and Take-up Reel Arm
Note: Make Sure the Reel is securely installed
4. Turn on Power
5. Install film to Super 8 Scanner (Please see “How to install film”)
6. Connect to USB to PC
6. Connect to USB to PC
7. Wait for LED light to turn “Orange”
8. Activate the CyberView S8 Software
9. Start to Digitize Your Super 8 Movie
9. Start to Digitize Your Super 8 Movie