Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Fiche De Données
Codes de produits
1-F8075
85
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
R T N b u t t o n . O r t h e
H O M E / E X I T b u t t o n i s
pushed.
<SensorTouch™>
RETURN
SWASH RING
Swash ring setting procedure
1. Activate the function:
Move the cursor to the [ACT] item and touch
Move the cursor to the [ACT] item and touch
the RTN button to switch to the data input
mode.
Select the ACT mode by scrolling the touch
sensor.
*The display blinks.
Touch the RTN button to activate the
function and return to the cursor mode.
2. Rate setting:
Move the cursor to the [RATE] item touch the
Move the cursor to the [RATE] item touch the
RTN button to switch to the data input mode.
Set the rate by scrolling the touch sensor.
Initial value: 100%.
Adjustment range: 50 to 200%.
Initial value: 100%.
Adjustment range: 50 to 200%.
*Adjust the rate to maximum swash tilt.
*When the RTN button is touched for one second, the rate is
reset to the initial value.
Touch the RTN button to end adjustment and
return to the cursor mode.
Limits the swash plate travel to within a fixed range. (Helicopter only)
This function limits the swash travel to a fixed
range in order to prevent damaging the swash
linkage by simultaneous operation of the ailerons
and elevators. It is very useful in 3D aerobatics
which use a large travel.
● The operating range display area:
The vertical direction shows the
The vertical direction shows the
elevator travel. The horizontal
direction shows the aileron travel.
● The marker shows the
stick position.
● Select [SWASH RING] in the Linkage
menu and access the setup screen
shown below by touching the RTN
button.
● When the swash ring function is activated,
a circle is displayed in the operating
range display area and the rate input box
is displayed. Stick operation is limited to
the area of this circle.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value