HP EW 5000 Digital Media Receiver Guide De Dépannage

wireless infrastructure troubleshooting tips

There are many steps for setting up a wireless network properly.

If you are having trouble, please read these tips for help in successfully adding

the hp digital media receiver to your wireless network.

There are two types of wireless networks: infrastructure and ad hoc.

In a wireless infrastructure network, all computers are connected through a common wireless access point device. This is the 
most common type of wireless network. If you have an infrastructure network, see the troubleshooting tips below.

In a wireless ad hoc network, computers communicate directly with each other without a common access point. This is not as 
common and may be used in smaller networks. If you have an ad hoc network (for instance, you have a PC with a wireless 
adapter and no wireless access point), see the ad hoc troubleshooting tips on the reverse side of this page.

For additional network terms, see the Glossary in the back of the User’s Guide.

wireless infrastructure troubleshooting

• Verify your access point is broadcasting its network name (called an SSID). See your access point’s User’s Guide and 

check the access point settings. Turn on options like “broadcast network name” or turn off “silent broadcast.”

• Cycle power on the access point, then run the DMR Setup Wizard again. To run the Setup Wizard, press the home 

button on the remote, then the options button. Highlight Run Setup Wizard and press select.

• Move the access point and the DMR closer together. Run the Setup Wizard again as per the above instructions.

• Check for firmware updates for your access point on the manufacturer’s website. Update the firmware on the access point 

and run the Setup Wizard again.

• Verify you have a functioning wireless network by using another wireless device.

• If you have a large number of photos or music files, wait until the synchronizing... message box disappears.

• Verify the hp digital media server is running. The server icon will be in the lower right corner of your server PC’s screen. To 

restart the media server, click Start, All Programs, hp digital media, then click Start hp digital media server.

• Verify the PC and DMR network IP addresses and Subnet masks are similar. See Page 36 of the User’s Guide to check the 

network address of your PC. For the DMR, press the options button, then select Network Setup and then Address. If 
they are not similar, disable your other PC network devices. Click Start, Control Panel, Network Connections and 
right click on any unused network connections. Select Disable from the menu that appears and reboot your PC.

• Verify the DMR scans and locates the correct WLan (SSID) for your access point. Run the Setup Wizard if there were any 

changes in the above steps.

• Verify the encryption (WEP) settings on your access point. You must use the exact same encryption key and settings on the 

access point and the DMR. See page 42 of the User’s Guide for more information on setting WEP keys.

• Verify the WLan signal strength as per page 44 of the User's Guide. If the signal strength is lower than 50%, move the 

DMR and the access point closer together.

• See  the  Network Setup and the Troubleshooting chapters in the User’s Guide.

• Change the channel on your access point and run the Setup Wizard again.

• If you have a firewall, grant access permission to the DMR. Try temporarily disabling the firewall to determine whether 

your firewall is preventing the DMR from accessing your PC.

• Rotate the DMR antenna for better reception.

© 2003 Hewlett-Packard Company. All rights reserved.

5 9 9 0 - 5 6 1 8