West Bend 41125 - Stand Mixer Manuel Du Propriétaire

Your mixer requires some assembly before using.  Do not plug cord into electrical 
outlet until after mixer is assembled and ready for 
operation.  

1.  To attach mixer to stand, press and hold down mixer 

release lever located on the back of the mixer stand.  
Position mixer head on stand so metal pin on 
underside of mixer fits into groove on mixer stand.  
Make sure mixer is securely attached to stand before 
using.  NOTE:  Mixer should not be used as a hand 
mixer.  It must always be used on the stand. 

2.  Place turntable onto platform of stand, aligning 

extension on underside into correct opening for the 
size bowl being used, Small or Large.  Lip on underside of bowl will fit into 
groove on turntable. 

3.  To insert beaters or dough hooks, press the lock release button located on side 

of mixer stand, lift mixer head up until it stops.  The beater or dough hook with 
the round collar fits into the round socket of the mixer head.  The beater with the 
hexagon collar fits into the hexagon socket of the mixer head.  Insert beaters by 
pushing shaft into socket, turning slightly if needed until they lock in place.  
Beaters must be inserted into correct socket, as they are not interchangeable. 

 

1.  Make sure speed control dial is set at the OFF position and mixer is securely 

attached to the stand before using.  NOTE: Mixer should not be used as a hand 
mixer.  Use only on stand.   

2.  Position turntable according to size bowl being used.  Position bowl onto 

turntable. 

3.  Insert beaters or dough hooks into correct sockets. 
4.  Add ingredients to bowl as recipe directs.  Plug cord into a 120 volt, AC 

electrical outlet only.  Turn speed control dial to start mixing.    Always begin 
mixing at a lower speed setting to prevent spattering, then increase to desired 
speed for mixing task.  Speed setting can be adjusted during operation by 
turning dial forward and back.  Use mixing guide as reference by aligning speed 
setting with indicator line.  A red light will illuminate next to the setting that was 
selected.  If you need to scrape the bowl during use, always turn mixer off, 
scrape then continue mixing. 

5.  When mixing is complete, turn speed control dial to OFF position and unplug 

cord from electrical outlet.  Press the lock release button and lift mixer head up 
until it stops.  Press the beater/hook release button located on side of mixer 
head and remove the beaters/hooks.  NOTE: Do not try to pull the 
beaters/hooks out of the mixer head without pressing the beater release button 
as damage to the mixer head could occur. 

 
• 

A small amount of smoke and/or odor may occur upon heating due to the 
release of manufacturing oils – this is normal.

4