Guardian Fall Protection Guardian Fall ProtectionGuardian Fall Protection GPS Receiver 6200 Manuel D’Utilisation

Guardian 6200

Copyright © 2006 Guardian Mobile Monitoring Systems, Inc.   All rights reserved.
www.guardianmms.com

The Guardian 6200 is a high-performance beacon designed for commercial vehicle applications that require location 
based services including productivity and security. It is ideally suited to installations in delivery and service fleets as 
well as public safety, mass transportation, utility, and off-road or construction vehicles.

Security features include vehicle theft detection and recovery as well as a means of connecting optional auxiliary 
sensors and panic buttons anywhere within the vehicle.

•  GPS Beacon device
•  Combined GPS/GPRS antenna
•  Wiring harness
•  Mounting bracket and hardware
•  Fuse panel connector kit

•  Wire cutters / wire strippers
•  Voltmeter (multimeter)
•  Soldering iron / solder
•  Electrical tape
•  Plastic cable ties
•  Screw drivers
•  Wrenches/sockets
•  In-line fuse holder (optional)
•  2-Amp fuse (optional)

The Guardian 6200 comes with a combined GPS/
GPRS antenna module. It is to be installed in a 
location where the GPS performance will be optimum. 
The integrated adhesive patch will allow easy 
attachment to a window or non-metallic panel.

Determine the best location for the GPS Antenna 

•  The antenna is to be installed inside the vehicle – it is 

not waterproof or weatherproof

•  The top side of the antenna module (identified by the 

peel-and-stick adhesive patch) must have a clear 
signal path to as much of the sky as possible

•  If the installation is not required to be covert, an ideal 

location is on the front windshield glass

•  For covert installations, an ideal location is under the 

dashboard, as high and close to the front windshield 
as possible (see diagrams)

•  If installing in a car, the antenna can usually be 

mounted on the rear window or in the trunk, under the 
rear deck, as close to the rear window as possible

•  If there is not a suitable flat mounting surface on 

which to stick the integrated adhesive patch, affix the 
antenna module in place with a caulking type adhesive 
or plastic tie wraps

•  Coil and secure any loose or extra lengths of antenna 

cables - do not allow antenna cables to kink

}

not necessary if 

using the fuse panel 

wiring method