Guardian Fall Protection Guardian Fall ProtectionGuardian Fall Protection GPS Receiver 6200 Manuel D’Utilisation
Installation Guide
Guardian 6200
Copyright © 2006 Guardian Mobile Monitoring Systems, Inc. All rights reserved.
www.guardianmms.com
www.guardianmms.com
As an alternative to soldering connections into
vehicle’s wiring, the supplied fuse panel connector
kit can be used for both the continuous power
connection and the ignition sense connection.
These accessory fuses are used as replacements
for existing 20A (Yellow) vehicle fuses, and
provide a fused connection point for the beacon,
removing the requirement for an inline fuse.
vehicle’s wiring, the supplied fuse panel connector
kit can be used for both the continuous power
connection and the ignition sense connection.
These accessory fuses are used as replacements
for existing 20A (Yellow) vehicle fuses, and
provide a fused connection point for the beacon,
removing the requirement for an inline fuse.
Many vehicles have extra power connections
available in the fuse box. These connections are
also an ideal source of 12 Volts provided they are
never switched off by any other vehicle function.
Many vehicles have more than one fuse box or
fuse block - check the vehicle’s owner’s manual.
available in the fuse box. These connections are
also an ideal source of 12 Volts provided they are
never switched off by any other vehicle function.
Many vehicles have more than one fuse box or
fuse block - check the vehicle’s owner’s manual.
• For the beacon’s power connection, use a
voltmeter or test light to find a fuse for a circuit that
has continuous power when the ignition and all
vehicle accessories are off.
has continuous power when the ignition and all
vehicle accessories are off.
• Replace this fuse with a supplied accessory fuse,
flip up the accessory terminal, crimp the supplied
spade connector to the power wire of the beacon
wiring harness, and slide it onto the accessory
terminal.
spade connector to the power wire of the beacon
wiring harness, and slide it onto the accessory
terminal.
• Repeat the above procedure for the ignition sense
connection, except select a fuse for a circuit that is
switched on and off with the ignition.
switched on and off with the ignition.
• The beacon’s ground wire will still have to be
connected to the vehicle chassis or an electrical
wire or connection point that is grounded to the
vehicle. This can be done using the supplied ring
terminal. Crimp it to the ground wire and screw
it to the vehicle chassis. Make sure the screw
and chassis are not painted or coated with
anything insulating.
wire or connection point that is grounded to the
vehicle. This can be done using the supplied ring
terminal. Crimp it to the ground wire and screw
it to the vehicle chassis. Make sure the screw
and chassis are not painted or coated with
anything insulating.
Accessory Fuse
Accessory
Terminal
Option 2 – Fuse Panel Wiring Method
WIRING CONNECTIONS
Colour
Function
Pin # Specification
Yellow/White
12V Power
15
+10.8 ~ +32 VDC
(2A max draw)
(2A max draw)
Green/White
Ground
16
0V
Red/White
Ignition Sense
13
High: +10.8 +32 VDC
Low: 0V
Low: 0V
Green
Panic Button
(optional)
(optional)
6
High: +10.8 +32 VDC
Low: 0V
Low: 0V
White
Aux Input
(optional)
(optional)
10
High: +10.8 +32 VDC
Low: 0V
Low: 0V
All other wires require no connection