Exide DEC200 Manuel D’Utilisation

Sales 

• Service • Recycling 1-888-563-6300

 

 

10

 

10.1. LED Descriptions 

 

Yellow Flashing 

High Rate Current 

Yellow Solid 

80% Charged 

Green Solid 

Charge Complete 

Red 

Fault – See page 15 for codes 

 

10.2.  PAUSE PUSH BUTTON 

 

This  PAUSE push button will halt the charge cycle. The battery can then be safely 
unplugged for up to 10 minutes.  If the battery is still connected after this time, the 
charger will continue with the present charge cycle. 

 

10.3 SMART 

START 

 

If the time to gassing voltage, (2.40 VPC), is less than 30 minutes, the normal charge 
profile will terminate and the unit will charge at constant voltage (2.35VPC) until 22% 
of the maximum current is reached.  The charger will then proceed to the auto-
balance stage. 

 

10.4 AUTO 

BALANCE 

 

The charger maintains a constant current level of 22% of maximum output that is 
activated by voltage, on at 2.20VPC and off at 2.40VPC with a time limit of 1 hour if 
2.40VPC is not reached.  
 
When current is flowing, amps will be displayed and the yellow LED will be 
illuminated. When no current is flowing, the display will show ‘StSt’. The FUNCTION 
button can select charge information. The green LED will remain illuminated. 
 
10.5 EQUALIZE 

STAGE 

 

Equalize charge consists of 12 hours at 22% of maximum output. 

 

The following table summarizes the action taken when Equalize is set manually 
during different charge modes… 

 

During recharge 

Equalize active after termination 

After charge termination  Equalize active immediately 
Smart Start termination 

Equalize active after termination