Beckett CULUS CF1400 Manuel D’Utilisation

Replace the oil supply line fi lter. The line fi lter 

cartridge must be replaced to avoid contamination 

of the fuel unit and nozzle.

Inspect the oil supply system. All fi ttings should be 

leak-tight. The supply lines should be free of water, 

sludge and other restrictions.

Remove and clean the pump strainer if applicable.

Replace the used nozzle with a new nozzle 

that conforms to the appliance manufacturer’s 

specifi cations. 

Clean and inspect the electrodes for damage, 

replacing any that are cracked or chipped.

Check electrode tip settings. Replace electrodes if 

tips are rounded.

Inspect the igniter spring contacts.

Clean the cad cell lens surface, if necessary.

Inspect all gaskets. Replace any that are damaged 

or would fail to seal adequately.

Inspect the combustion head and air tube. Remove 

any carbon or foreign matter. Replace all damaged 

units with exact parts.

Clean the blower wheel, air inlet, air guide, burner 

housing and static plate of any lint or foreign 

material.

If motor is not permanently lubricated, oil motor with 

a few drops of SAE 20 nondetergent oil at each oil 

hole. DO NOT over oil motor. Excessive oiling can 

cause motor failure.

Check motor current. The amperage draw should 

not exceed the nameplate rating.

Check all wiring for secure connections or insulation 

breaks.

□

□

□
□

□

□

□
□
□

□

□

□

□

□

Model

Flange A

Flange B

Flange C

CF1400

51312

(10.00” DIA.)

n/a

51629

(12.25” DIA.)

CF2300

51313

(12.44” DIA.)

51498

(13.92” DIA.)

51630

(16.00” DIA.)

Check the pump pressure and cutoff function.

Check primary control safety lockout timing.

Check ignition system for proper operation.

Inspect the vent system and chimney for soot 

accumulation or other restriction.

Clean the appliance thoroughly according to the 

manufacturer’s recommendations.

Check the burner performance. Refer to ‘Set 

High-fi re Air’ section and set combustion with test 

instruments.

It is good practice to make a record of the service 

performed and the combustion test results.

Observe combustion air openings and vent system 

for integrity. Openings must be clean and free of 

obstructions.

Check oil lines and fi ttings to verify there are no leaks.

Observe burner ignition and performance to verify 

smooth operation.

Shut the system down if you observe abnormal 

or questionable operation. Call a qualifi ed service 

agency for professional inspection and service.

□
□
□
□

□

□

□

□

□
□

□

Do not tamper with the burner or controls or make 

any adjustments unless you are a trained and 

qualifi ed service technician.
To ensure continued reliable operation, a qualifi ed 

service technician must service this burner annually.
More frequent service intervals may be required in 

dusty or adverse environments.
Operation and adjustment of the burner requires 

technical training and skillful use of combustion test 

instruments and other test equipment.

y

y

y

y