Emerson 5-In-One Learning Light-Up Remote Manuel Du Propriétaire

11

Preparation

Note: Once you have programmed 

 for Favor-

ite Channel Scan, you cannot use it for Channel Scan
unless you reset it (see “Resetting Scan”).

1. Select 

 or 

 for the favorite channel scan. 

2. Hold down 

 until the red light blinks twice.

3. Press 

 to start the program. 

4. Enter the two-, three- or four-digit number for your

favorite channel.

5.

If you entered less than four digits

, you must do one

of the following: if your original remote requires you
to press Enter or Select to send a command, then
do so after entering the digits of your favorite chan-
nel. If your original remote does not require you to
press Enter or Select to send a command, then after
entering your two- or three-digit channel number,
press 

.

If you entered a four-digit channel number

, do not

press 

.

6. Repeat Steps 4–5 up to nine more times to store

another favorite channel for the same device, or exit
the program by pressing 

 until the red light blinks

twice.

Note: Upon entering the 10th channel, the remote
exits the Favorite Channel Programming mode.

Programming Favorite Channel Scan for a second de-
vice deletes the programming for the first.

Once you have programmed 

 for Favorite

Channel Scan, you cannot use it for Channel Scan un-
less you reset it.

To reset 

, follow these steps.

1. Select either 

 or 

. 

2. Hold down 

 until the red light blinks twice.