Bühler 2895 Manuel D’Utilisation
bühler
Allied Front-End Loader
- 22 -
P4410
LUBRICATION
Lubricate loader bushings and pivots every eight hours of average operation
with high-grade grease. For grease fitting locations see illustration below.
Select grease based on the expected outside temperature range. Lithium,
Molybdenum and synthetic greases are preferred. Use the tractor hour meter
as a guide. Increase lubrication intervals for extreme use or adverse
conditions. Each pivot should be lubricated until grease is visible at pin.
with high-grade grease. For grease fitting locations see illustration below.
Select grease based on the expected outside temperature range. Lithium,
Molybdenum and synthetic greases are preferred. Use the tractor hour meter
as a guide. Increase lubrication intervals for extreme use or adverse
conditions. Each pivot should be lubricated until grease is visible at pin.
TSL Loader Shown
IMPORTANT: Ensure that grease fittings accept grease. Should any fitting
become plugged, replace immediately. Pivots not greased as specified would
cause premature wear of pins and bushings.
become plugged, replace immediately. Pivots not greased as specified would
cause premature wear of pins and bushings.