Whirlpool W10258095A Manuel D’Utilisation
4
The fourth (grounding) conductor must be identified by a green or
green/yellow cover and the neutral conductor by a white cover.
Cord should be Type SRD or SRDT with a UL listed strain relief
and be at least 4 ft (1.22 m) long.
green/yellow cover and the neutral conductor by a white cover.
Cord should be Type SRD or SRDT with a UL listed strain relief
and be at least 4 ft (1.22 m) long.
The minimum conductor sized for the copper 4-wire power
cord are:
cord are:
40-amp circuit
2 No.-8 conductors
1 No.-10 white neutral
1 No.-8 green grounding
2 No.-8 conductors
1 No.-10 white neutral
1 No.-8 green grounding
If connecting to a 3-wire system:
Local codes may permit the use of a UL listed, 3-wire, 250-volt,
40- or 50-amp range power supply cord (pigtail). This cord
contains 3 copper conductors with ring terminals or open-end
spade terminals with upturned ends, terminating in a NEMA Type
10-50P plug on the supply end. Connectors on the appliance end
must be provided at the point the power supply cord enters the
appliance. This uses a 3-wire receptacle of NEMA Type 10-50R.
40- or 50-amp range power supply cord (pigtail). This cord
contains 3 copper conductors with ring terminals or open-end
spade terminals with upturned ends, terminating in a NEMA Type
10-50P plug on the supply end. Connectors on the appliance end
must be provided at the point the power supply cord enters the
appliance. This uses a 3-wire receptacle of NEMA Type 10-50R.
INSTALLATION INSTRUCTIONS
Unpack Range
1. Remove shipping materials, tape and film from range.
2. Remove oven racks and parts package from inside oven.
3. Do not remove the shipping base at this time.
4. On Ranges Equipped with Storage Drawers:
Remove the storage drawer. If a range height adjustment is
necessary, use a ¼" drive ratchet to lower the rear leveling
legs one-half turn. Use a wrench or pliers to lower front
leveling legs.
necessary, use a ¼" drive ratchet to lower the rear leveling
legs one-half turn. Use a wrench or pliers to lower front
leveling legs.
On Ranges Equipped with Warming Drawers:
If a range height adjustment is necessary, use wrench or pliers
to lower the front and rear leveling legs.
to lower the front and rear leveling legs.
4-wire receptacle (14-50R)
3-wire receptacle (10-50R)
A. Shipping base
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
A
A. ¼" drive ratchet
B. Rear leveling leg
B. Rear leveling leg
C. Wrench or pliers
D. Front leveling leg
D. Front leveling leg
A. Rear leveling leg
B. Front leveling leg
B. Front leveling leg
C. Wrench or pliers
A
B
C
D
A
B
C