RayTek ThermoView Ti30 Manuel D’Utilisation

Power is switched on or off by opening or closing the lens door. Sliding down the 
lens door turns the imager on (see Figure 6 below). Slide the door up to turn off the 
imager.

Open
(Unit On)

Closed
(Unit Off)

The unit is self-protected against excessive levels of infrared radiation and it will 
cause the unit to automatically shut down. If that happens, slide the lens door 
closed, wait a minute and slide it open again. 

Always dock the imager in the docking station when not in use. By doing so, 
you will assure the batteries will be always fully charged when using the 
rechargeable battery pack. The image will not show thermal images or 
respond to controls while it is in the docking station. 

The ThermoView imager performs an initial auto-check each time it is activated and then 
immediately shows the Information Screen. The Information Screen displays the 
following information about the ThermoView imager unit: 

July 1, 2003 

- 15 - 

Version 1.0