Vauxhall Combo Manuel Du Propriétaire

Picture no: 11645s.tif

4. Before attaching the jack 3, set it to the 

required height by turning the lug by 

hand. Fit the jack arm at the front – or 

rear – in such a way that the jack claw 

(arrow in figure) goes around the vertical 

ridge and engages in the recess in the 

ridge. Ensure that the claw is properly 

positioned.

Picture no: 11646s.tif

The edge of the jack base must be 

planted firmly and vertically in line with 

the contact point.
Raise vehicle by turning crank handle. 
If this is not the case, carefully lower the 

vehicle immediately and reposition the 

jack.

5. Unscrew the wheel bolts and wipe clean 

with a cloth. Lightly grease the wheel 

bolt taper. Make sure that the bolt 

threads are not greased. Place the 

wheel bolts where they will not become 

dirty.
On some model variants, the wheel trim 

is removed together with the wheel 

bolts.
The retaining rings 3 at the wheel bolts 

must not be removed.

6. Change the wheel. For information on 

the spare wheel – see page 149; for 

information on the temporary spare 

wheel – see pages 137, 150, 205.