Ultimate Technology 500 POS Manuel D’Utilisation

Table 3.  Local Mode Programming Instructions - Continued 

Note: *Default Settings 

Function Code(s) 

Operation 

Normal Indication 

 

Remarks 

on Series 500 Keyboard numeric keypad or by swiping the Programmer's 
card.  If using the optional 3-position keyswitch, move switch out of the 
AUX position.  

90 

Dump System Log 

This is a command used to read out the Series 500 Keyboard system log data at the 
main port.  For detailed information about retrieving the system log data, refer to the 
Maintenance Section of this manual. 

91 

Main Port Select 

1. While in programming mode, at Series 500 Keyboard numeric keypad, enter Function 

Code 91. 

 
       

LED (2) turns on. 

 
2. At Series 500 Keyboard numeric keypad, enter the applicable number (0 or 1) to 

select LED mode of operation per list below. 

 
       

0 = Keyboard Port 0 is main 

       

1 = RS232 Port 0 is main 

 
 
       

LED (2) turns off. 

 
3. Program the next function code or exit programming mode by entering 99 on Series 

500 Keyboard numeric keypad or by swiping the Programmer's card.  If using the 
optional 3-position keyswitch, move switch out of the AUX position. 

 
  Note:  Must re-power Series 500 Keyboard in order to activate function code. 

96 

Set Secure Mode 

1. While in programming mode, at Series 500 Keyboard numeric keypad, enter Function 

Code 96 

 
2. At Series 500 Keyboard numeric keypad, enter the applicable number (0 or 1) to 

select override secure mode of operation per list below. 

 
       

0 = not secure 

       

1 = secure 

 
       

LED (2) turns off. 

 
3. Program the next function code or exit programming mode by entering 99 on Series 

500 Keyboard numeric keypad or by swiping the Programmer's card.  If using the 
optional 3-position keyswitch, move switch out of the AUX position.