Stow Grinder DFG Series Manuel D’Utilisation

 

 

INSTALLING THE SG24-1000 SAFETY AND DUST 
SHIELD ASSEMBLY KIT. 
 
Application: All Models. 
 
Tools Required:  
1 each, 5/32 inch Allen wrench. 
1 each, 7/16 inch wrench. 
2 each, 1/2 inch wrenches. 
1 each, flat blade screwdriver. 
 
1)  If the SURFACE GRINDER is powered by an 

engine, disconnect the spark plug wire. If 
powered by an electric motor, properly 
disconnect the extension cord or SURFACE 
GRINDER from the power source. 

2)  Using the allen wrench, remove the bumper 

guard P/N 29018-016 from the machine. 

3)  Tilt the SURFACE GRINDER back until the 

operator handle comes in contact with the 
surface. The SURFACE GRINDER may not be 
in a stable position in this configuration. To 
minimize the possibility of property damage 
and/or personnel injury, properly secure an 
appropriate weight to the handle for added 
stability. Other means can be utilized to support 
the frame and provide proper machine stability. 
Appropriate wheel chocks are also 
recommended. FIGURE 1. 

 

 

 

4)  Using the 7/16-inch wrench, install the wrap-

around rubber skirt P/N 29018-88 around the 
outside perimeter surrounding the multi-
accessory discs. Secure with cap screws P/N 
106499-007 and washers P/N 29018-090. The 
original bumper and cap screws can also be 
utilized as an alternative attachment method. 
The notches in the rubbers skirt are provided as 
a means to compensate for multi-accessory 

attachment wear (if applicable). Adjust the 
location of the rubber skirt to provide the 
necessary clearance between it and the work 
surface. Improper clearance will accelerate skirt 
wear. FIGURE 2. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 1 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 2 
 
5)  Using the 1/2-inch wrenches, the rectangular 

rubber skirt P/N 29018-089 is attached to the 
middle support member of the main frame. 
Proper installation will have the hose attach 
fitting that is riveted to the skirt facing the rear of 
the machine.  The notches in the rubber skirt are 
provided as a means to compensate for multi-
accessory attachment wear (if applicable). 
Adjust the location of the rubber skirt to provide 
the same clearance as with the wrap-around 
rubber skirt P/N 29018-088. The skirt straps PN 
29018-092 provide additional support for the 
rear skirt assembly. Properly secure with the cap 
screws PN 06500-007 and self-locking nuts P/N 
08233-005. FIGURE 3.