Troy-Bilt 70 Manuel D’Utilisation

A

B

C

NOTE: The bag must 
be removed before 
installing the blower 
chute.

7.  Grasp bag handle with one hand and slide locking rod 

on mounting bracket with other hand toward engine. 
Use the end of mounting bracket as leverage when 
sliding the locking rod.
a.  Slip bag over the rim of the discharge opening and 

release locking rod to secure bag in place. See 
Figure 3-7.

b.  Snap bag clip to the top of the lower handle.
c.  Place the lower straps on the bag over the top 

of lower handle, hooking them on the studs. See 
Figure 3-7.

NOTE: The bag/chute switch button attached to the 
mounting bracket must be fully depressed by the tip of 
front tab on bag handle when securing the bag or engine 
will not start.

NOTE: The bag must be removed before installing the 
blower chute.

8.  a. Grasp blower chute with one hand and slide locking 

rod on mounting bracket with other hand toward 
engine. Use the end of mounting bracket as lever-
age when sliding the locking rod. See Figure 3-8.

  b. Slip blower chute over rim of discharge opening 

and release locking rod to secure chute in place.

  c.  Raise the nozzle height to the highest setting when 

using the blower chute. Refer to nozzle height 
adjustment in the OPERATING YOUR CHIPPER/
SHREDDER VACUUM section.

NOTE: The bag/chute switch button attached to the 
mounting bracket must be fully depressed by the tip of 
front tab on the blower chute or engine will not start.