Paxton Automotive Novi 2000 Supercharger 1201810 Manuel D’Utilisation
10-1
P/N: 4809644
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
13DEC04 v2.0 03-05Viper(4809644v2
.0)
Section 10
AIR INLET DUCT INSTALLATION
10.
AIR INLET DUCT INSTALLATION
A.
Install the supplied 4" bump sleeve onto the
supercharger inlet.
supercharger inlet.
B.
Install the supplied grommet into the hole in
the back of the air inlet.
the back of the air inlet.
C.
Insert the 4" hose barb of the supplied inlet
duct into the open end of the bump hose.
duct into the open end of the bump hose.
D.
Start the supplied 1/4-20 hardware into the
original air box hold down locations. Drill
the remaining two holes in the air inlet duct
through the radiator fan shroud. (See Fig.
10-a.)
original air box hold down locations. Drill
the remaining two holes in the air inlet duct
through the radiator fan shroud. (See Fig.
10-a.)
F.
1
.
(2003-2004 vehicles)
Using the supplied
5/8" hose menders and hose, connect the fac-
tory crankcase vent hose to the grommet
installed in the air inlet duct. Secure with zip
ties. (See Fig. 10-c1.)
tory crankcase vent hose to the grommet
installed in the air inlet duct. Secure with zip
ties. (See Fig. 10-c1.)
2.
(2005 vehicles)
Remove the plastic hose
from the passenger side valve cover and use
the supplied 1/2" hose and hose mender to
connect the valve cover to the grommet
installed in the air inlet duct. (See Fig. 10-
c2.)
the supplied 1/2" hose and hose mender to
connect the valve cover to the grommet
installed in the air inlet duct. (See Fig. 10-
c2.)
Fig. 10-a
Fig.
10
-c2 (2005 vehicles)
E.
Install the supplied 1/4-20 nut plates onto
the newly drilled holes in the radiator
shroud. (See Fig. 10-b.)
the newly drilled holes in the radiator
shroud. (See Fig. 10-b.)
Fig.
10
-c1 (2003-2004 vehicles)
Fig. 10-b