Trane TRACER SUMMIT BAS-APG001-EN Manuel D’Utilisation

The EX2 module is shipped with terminal strips already in place 
(Figure 45). If you need to replace the circuit board, you can transfer the 
terminal strips to the new board without rewiring. 

To mount the enclosure:

1.

Unscrew the two screws on the front of the enclosure and remove the 
cover.

2.

Using the enclosure as a template, mark the location of the four 
mounting holes on the mounting surface (Figure 46 on page 88).

3.

Set the enclosure aside and drill holes for the screws at the marked 
locations.

4.

Drill holes for #10 (5 mm) screws or #10 wall anchors. Use wall 
anchors if the mounting surface is dry wall or masonry.

5.

Insert wall anchors if needed.

6.

Secure the enclosure to the mounting surface with #10 (5 mm) screws 
(not included).

Binary outputs
terminal strip

Analog outputs
terminal strip

Universal inputs
terminal strip