Panasonic Arbitrator 360 Mode D’Emploi

108

109

Before requesting service, check the points listed below. If the problem persists, contact your supplier.

•  Check whether power cable (included in the sold separately Cable Kit) is connected 

correctly.

•  If you have set a refer to “PowerOff Time” on page 81 and are running the recorder with 

the ignition switch at LOCK (OFF), turn the ignition switch on and reboot the recorder 

(see “Rebooting This Unit” on page 76).

•  If the operating environment is hotter than the recommended temperature, the recorder 

may turn off for safety reasons. If this happens, wait for the operating environment to 

cool down before using the unit.

• Are you using the supplied key?

•  Is the SDHC Memory Card slot cover closed? The key can only be removed if the SDHC 

Memory Card slot cover is closed.

•  Is an SDHC Memory Card inserted correctly in an SDHC Memory Card slot?

•  To reset the recorder, keep pressing the [REC] button and [STOP] button on the recorder 

together for about 10 seconds. When resetting, after all lamps turn off (1 or  seconds) 

and then on (1 or  seconds), all lamps blink.

•  If the button lock is enabled (“ANY” or “STOP”), change the setting to “OFF” (see 

•  If you remove the SDHC Memory Card during SDHC Memory Card access ([BUSY] lamp 

is lit), the SDHC Memory Card slot may become inoperative. In such a case, the recorder 

automatically restarts itself, and the card slot will become operative again.