Texas Memory Systems RamSan-325/325c Manuel D’Utilisation

 

 

 

RamSan-325/325c User’s Manual 

 

- 28 - 

Talk to your network administrator for the proper IP assignment 
type. The default factory setting is DHCP. Use the “Select” button 

to select the desired method of IP assignment. If you did not 
choose “Static IP” you are asked to confirm the selection with the 
“↓” button. 

 
To configure the RamSan with a static IP, the system requires the 
IP address, subnet mask, and a possibly a gateway address.  

 

After you have chosen 

“Static IP,” “Ethernet IP” 
replaces the top line of the 

display, and the display 
prompts you to enter an IP. 
Use the “↑” or “↓” buttons 

to cycle through the 

numbers “0” through “9”. 
To select the value, use the 

“Select” button. Then, the 
input prompt moves to the 

next character position. To 
back up a space, press the 
“↑” and “↓” button 

simultaneously. Repeat this 

procedure until you have 
entered the 4-byte address. 

Press the “Menu” button at 
any time to cancel the 

Static IP assignment.  

 

 

After you have finished 

entering the IP, the top line 
of the front panel changes 

to “Subnet Mask.”  Using 
the same procedure as 

entering the IP address, 
enter the subnet mask.  

 

 

The final value you must 
enter is the “Gateway 

Address.” If the RamSan is 
on a private network and 

this value is not needed, 
enter the value “0.0.0.0” to 

tell the RamSan to ignore 
this entry.  

 

 

After entering all three values, the display prompts you to confirm 
the command with the “↓” button. 

 

Ethernet IP 

_ 

Subnet Mask 

_ 

Gateway Address 

_