The 3G Gateway requires some basic
configurations before it can be used. It will be
necessary to find the IP-address and to create
the dial-in and dial-out services to program
the ISDN-PRI Line numbers.



Make sure the 3G Gateway is

Off

and

connect an RS232 cable between the
3G Gateway and a PC.



Switch on the 3G Gateway.



Start a terminal program on the PC and

configure it to:

115200, 8, 1, None

Configuring via the RS 232



To assign a

static IP-address

, type

Xconf ip Assigment: “Static”

and

Xconf ip address <IPAddr>

To assign an

IP Subnetmask

, type

Xconf ip address subnetmask

To assign an

IP Gateway

address, type

Xconf ip address gateway



Restart the 3G

Gateway.



Start a WEB browser

and enter the IP-
address of the 3G
Gateway. Default
password:

TANDBERG

Note the case sensitivity!



To configure the 3G

Gateway for UMTS
dial-in, enter PRI or BRI
numbers and dial in
number(s). For details,
see

Configuring the 3G

Gateway



To configure the 3G Gateway for IP dial in, register the 3G Gateway to a Gatekeeper and

enter H.323 services. For details, see

Configuring the 3G Gateway

As an alternative to the configuration via
RS 232 you may use the LCD panel to
configure and check the IP settings, as well as
to reboot the system. This is outlined on the
next page.

Power switch

Configuring Your 3G Gateway via the RS 232

About Gateway Configuration

Configuration via the Front Panel