The LCD panel makes it possible to configure
and check the IP settings as well as to reboot
the system. The front panel LCD menu items
are as follows:

The 3G Gateway requires some basic
configurations before it can be used. It is
necessary to configure the IP-address and
to create the dial-in and dial-out services to
program the ISDN-PRI Line numbers.

As an alternative to the configuration via the LCD
Panel you may use RS 232 to configure and the
system. This is treated on the previous page.

UP key

DOWN key

ESC

key

ENTER key

Configuring the IP Address via the Front Panel



Switch on and press any key to produce

the

Main Menu

. Use

DOWN

navigate to the

IP Settings

, if needed.



Press

ENTER

to access the

IP Settings

submenu.



Use the

DOWN

keys to select

Address



In addition to configure the IP address you

must also configure the default-gateway,
netmask and set IP assignment to static.



Press

ENTER

again to produce the

cursor.



Use

DOWN

keys to navigate

between the digits of the number.



Use

ENTER

to enter

Digit Altering

Mode



Use

DOWN

to alter the digit value.



Press

ENTER

as many times as needed

to move to the next digit to be altered
and alter this digit.



When finished editing use

ESC

to go to

the

Confirm change

menu.

Use the

DOWN

key to select

yes

and

ENTER

to confirm.

Use

ESC

key to navigate back to the

main menu.

DHCP assigned IP-addresses are supported by the TANDBERG 3G Gateway (factory default).

IP Settings
IP Information
Commands

IP Address
IP Netmask
IP Default GW

IP Address

Reboot

Main Menu

IP Settings

IP Information

Commands

Menu Hierarchy

Configuring the IP Address via the Front Panel

About 3G Gateway Configuration

Configuring via the Front Panel

Power switch

Switching On the Unit

Configuration via RS 232