TANDBERG 7000 MXP Manuel D’Utilisation

TANDBERG 7000 MXP 

236 

6 Audio Inputs:  

ƒ  3 microphone inputs (balanced, 24V phantom powered) via XLR connectors. 
ƒ  3 audio inputs (line level) via RCA connectors.  

 
 
All audio inputs are active by default. For further information, refer to chapter 

Audio

. 

 
Audio input connector specification: 

Signal type 

Balanced 

Unbalanced 

Connector (codec) 

XLR-F, pin 1-gnd, 
pin 2 hot, pin 3-
cold/neutral 

Female RCA/phono, 
sleeve-ground, 
centre-signal 

Input impedance  

2400 ohms (pin 2 - 
3) 

10K ohms 

Max input level when 
set to minimum input 
level 

83 mVpp 

15.5 Vpp 

Max input level when 
set to maximum 
input level 

6.2 mVpp 

1.2 Vpp 

Range, menu 
adjustable input gain 

22.5 dB (16 steps of 
1.5 dB) 

22.5 dB (16 steps of 
1.5 dB) 

Phantom power 
voltage 

24 V +/- 5% 

- 

Phantom power 
resistor, pin 2 

1200 ohms 

- 

Phantom power 
resistor, pin 3 

1200 ohms 

- 

Max phantom power 
current pr mic 

12 mA 
 

- 

 
3 Audio Outputs:  

ƒ  1 output (line level) via RCA connector providing audio from far end, in addition to dial 

tones. This output also supports S/PDIF. S/PDIF (Sony/Philips Digital Interface) is used 
by the Digital Natural Audio module. 

ƒ  1 AUX output (line level) via RCA connector providing a mixed signal between audio from 

the local side (except from the AUX input) and audio from the far end. This output is 
intended for connection to a telephone add-on system. When system is configured as 
stereo, this output will provide the left stereo information. 

ƒ  1 VCR output (line level) via RCA connector providing a mixed signal between audio from 

the local side (except from the VCR input) and audio from the far end. This output is 
intended for connection to a VCR. When system is configured as stereo, this output will 
provide the right stereo information. 

 

 
Audio output connector specification: