TANDBERG 7000 MXP Manuel D’Utilisation

TANDBERG 7000 MXP 

238 

 

Ethernet: 
1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to 4 or 6 Mbps depending on the 
bandwidth option installed. 
 
To connect the system to a LAN, use the Ethernet cable provided by TANDBERG (or a standard 
Ethernet cable). 
 
The cable specification is: 
 
1 ------------ 1 
2 ------------ 2 
3 ------------ 3 
6 ------------ 6 
 
 If no LAN is available and the codec is connected directly to a computer, use a crossover cable. 
 
The crossover cable specification is: 
 

 

 
If such a connection is needed, the system and the PC must use ‘static’ TCP/IP settings because 
no DHCP server is controlling the small “LAN”, which has been created between the computer 
and the system. When configuring a back-to-back connection between the PC and the system, 
make sure both static IP addresses exist on the same subnet. 
 
ISDN BRI Interface: 
ISDN I.420 (RJ-45 Jack) Basic Rate Interface S/T (2B+D), 128 kbps per ISDN I/F 
 
To connect the system to BRI, use the ISDN cable provided by TANDBERG (or a standard BRI 
cable). 
 
The pinout of the S/T interface is: 

Pin-3  

TX+ 

Pin-4  

RX+ 

Pin-5  

RX- 

Pin-6  

TX- 

 
 
ISDN PRI Interface: 
1 x PRI  (RJ-45 Jack) Primary Rate & Leased Line E1/T1 (G.703) Interface up to 2 Mbps 
1 x PRI (RJ-45 Jack) Primary Rate (for future use). 
 
To connect the system to PRI, use the ISDN cable provided by TANDBERG (or a standard PRI 
cable).